UTMI
The second point is to set the injection procedure, including the injection speed and injection volume of the injection liquid;
Secondly, the third point, select any brand of syringe to be used (general syringe pumps can use syringes produced by any manufacturer), according to the specifications of the syringes required by the brand of the syringe pump, use the syringe to extract the liquid, and exhaust the air. Empty, then fix the syringe in the syringe fixing groove of the syringe pump, and connect the corresponding catheter to the venous channel.
After the stock is ready, at the fourth point, press the start button to start the injection.
The fifth point, after the injection is completed, pull out the needle, turn off the power, and wipe the syringe pump for next use.
Precautions for the use of syringe pumps?
1. If there is an alarm when the syringe pump is in use, the alarm should be eliminated in time. The common alarm conditions are pipeline blockage and liquid exhaustion. 2. When changing the liquid medicine when the syringe pump is used, the intravenous channel should be clamped first and the injection should be suspended. Run the pump, take out the syringe, and place the syringe in the fixing groove of the syringe pump after changing the liquid medicine. Repeat the injection procedure according to the second point of the above-mentioned use method of the syringe pump. After opening the channel, start the syringe pump.
3. The ambient temperature of the syringe pump should be <45℃, and the operation of the syringe pump is stable at this temperature.
4. The general setting range of the injection running rate of the syringe pump should be set within the range of 0.1-100ml/h. In general, it is not used for rapid infusion considering the human body's endurance.
5. When installing the syringe, do not forcefully rotate the clip and slide the propeller forcefully to prevent too much liquid from entering the body.
